Thursday, April 25, 2019

Lab report in DC Voltage Regulators Assignment Example | Topics and Well Written Essays - 1250 words - 1

Lab report in DC Voltage Regulators - Assignment ExampleTypically, Zener diodes are think to offer constant output voltage to a given payload connected parallel to it disregardless of the variations in voltage supply or load current fluctuations. The diode regulates the voltage continuously for as long as the current lies below borderline value. The diode allows current to flow forward complaint although when a Zener voltage is reached, the current is allowed to flow in the reverse direction.Basically, a voltage governor is tasked with precaution of a constant voltage through a load irrespective of variations in applied input voltage as well as variations in load current. For a conventional Zener diode electrical shunt regulator, the resistor is chosen in such manner that when input voltage is at minimum (VIN(min)) and load current is at maximum (IL(max)), then the current flowing through Zener diode is at minimum (Iz(min)).Then for all other arrangements of input voltage as well as load current, the Zener diode conducts excess current therefore kee trammelg a constant voltage via the load. The Zener transmits the minimum current when shipment current is maximum and conducts maximum current when load current is the minimal.This is a type of voltage regulator used for positive voltage which might be set using selected two resistors that are connected betwixt output and ground. Its capability is often dependent on style made use of. It has some different casing ranging from SOIC-8 to TO-3. Rather than having an Input, an Output and a Ground, it has an Input, an Output and a Reference.Alternatively, when the LM317 is meant to regulate output at 1.25 Volts above Reference pin, the value of the resistor sets current across the resistors. The current obtained by reference pin is meager and may be ignored for as long as resistor current lies between 1 mA and 10 mA.Giving R1 a standard value, such as 120 or even 240 Ohms, the current is set through R2 also. All one has to do

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.